Installing the I/O board
1. Place the I/O board on the computer.
2. Tighten the screws to secure the I/O board to the computer.
3. Connect the display assembly cable to the computer.
4. Connect the I/O cable to the computer.
5. Tighten the screw to secures the I/O board.
6. Slide the I/O board into its place on the computer.
7. Close the I/O bay press latch door.
8. Install:
a. base cover
b. optical drive
c. hard drive
d. battery
9. Follow the procedure in After working inside your computer.
Driving board
Removing the driving board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the driving board:
a. Peel the adhesive tape to access the display assembly cable [1].
b. Disconnect the display assembly cable [2].
c. Peel the adhesive tape to access the I/O cable [3].
d. Disconnect the I/O cable [4].
e. Remove the screws that secure the driving board to the computer [5].
f. Lift the driving board from the computer [6].
42
To Next Page
Loading...
