GPS board
Removing the GPS board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the GPS board:
a. Disconnect the antenna cable from the GPS board [1].
b. Disconnect the GPS board cable from the connector [2].
c. Remove the screw that secures the GPS board to the computer [3].
d. Lift the GPS board away from the computer [4].
Installing the GPS board
1. Place the GPS board into the slot on the computer.
2. Tighten the screw to secure the GPS board to the computer.
3. Connect the antenna cable to the connector on the GPS board.
4. Connect the GPS board cable to the connector.
5. Install:
a. base cover
b. optical drive
c. hard drive
d. battery
6. Follow the procedure in After working inside your computer.
32
To Next Page
Loading...
