Option Description
USB Wake
Support
You can enable USB devices to wake the system from Standby.
NOTE: This feature is only functional when the AC power adapter is
connected. If the AC power adapter is removed during Standby, the system
setup removes power from all the USB ports to conserve battery power.
The option is:
• Enable USB Wake Support
This option is disabled by default.
Wireless Radio
Control
You can enable or disable the feature that automatically switches from wired or
wireless networks without depending on the physical connection.The options are:
• Control WLAN Radio
• Control WWAN Radio
This option is disabled by default.
Wake on LAN/
WLAN
You can enable or disable the feature that turns on the computer from the Off
state:
• When triggered by a LAN signal
• From the hibernate state when triggered by a special wireless LAN signal
The options are:
• Disabled. This option is set by default.
• LAN Only
• WLAN Only
• LAN or WLAN
Block Sleep You can block entering to sleep (S3 state) in operating system environment. The
option is:
• Block Sleep (S3 state)
This option is disabled by default.
Peak Shift You can minimize the AC power consumption during the peak power times of day.
After you enable this option, your system runs only in battery even if the AC is
attached. The option is:
• Enable Peak Shift
This option is disabled by default.
Advanced Battery
Charge
Configuration
You can maximize the battery health. By enabling this option, your system uses the
standard charging algorithm and other techniques, during the non-work hours to
improve the battery health. The option is:
81
To Next Page
Loading...
