3 Connect the rear camera cable to the system board.
4 Install the:
a front camera
b display panel
c uSIM/microSD
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
5 Follow the procedure in After working inside your tablet.
Smart Card Cage
Removing the smart card cage
NOTE: Always remove the smart card from the smart card reader.
1 Follow the procedure in Before working inside your tablet.
2 Remove the:
a uSIM/microSD card
NOTE: uSIM card slot is available only on tablets shipping with WWAN module.
b display panel
3 To disconnect the cables:
a Lift the latch and dDisconnect the smart card cable from the smart card cage [1].
b Remove the M2.0 x 2.5 screws (3) from the smart card module [2].
c Lift the smart card cage from the tablet [3].
Removing and installing components
25