Steps
1. Place the palmrest assembly on a flat surface.
2. Transfer over the components to the new palmrest assembly.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a. Keyboard
b. System board
c. Power button with finger print reader
d. I/O board
e. Smart card reader
f. Speakers
g. Display assembly
h. Heatsink assembly
i. Palmrest antenna (optional)
j. WLAN antenna bracket
k. WWAN card
l. Solid state drive
m. Battery
n. Base cover
2. Follow the procedure in After working inside your computer.
48
Removing and installing components
To Next Page
Loading...
