2
Removing and Installing Components
This section provides detailed information on how to remove or install the components from your computer.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Removing the ATG Handle
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the screws that secure the ATG handle to the computer.
3. Remove the right ATG port cover.
Installing the ATG Handle
1. Secure the ATG handle by tightening it with the screws.
2. Follow the procedures in
After Working Inside Your Computer
.
11
To Next Page
Loading...
