Dell Latitude E6430 - Installing the Input Output (I;O) Board; Removing the Hard-Drive Support Plate

4. Remove the I/O board from the computer.
Installing the Input Output (I/O) Board
1. Place the I/O board in its compartment.
2. Tighten the screws to secure the I/O board.
3. Install:
a) system board
b) ExpressCard cage
c) media board (available in E6430/E6430 ATG only)
d) palmrest
e) display assembly
f) keyboard
g) keyboard trim
h) bluetooth card
i) hard drive
j) optical drive
k) base cover
l) battery
4. Follow the procedures in After Working Inside Your Computer .
Removing the Hard-Drive Support Plate
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) battery
b) base cover
c) hard drive
d) bluetooth card
e) keyboard trim
f) keyboard
g) display assembly
h) palmrest
i) media board
j) ExpressCard cage
k) system board
40