Dell PowerEdge R7615 - Installing the Rear Mounting Front PERC Module

4. Remove the drive backplane cover.
5. If required, remove the air shroud or remove the GPU air shroud..
6. If required, remove the drive backplane cover.
7. Disconnect all the cables, observe the cable routing.
NOTE: Refer Cable routing topic for more information.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 98. Removing the rear mounting front PERC module
Next steps
1. Replace the rear mounting front PERC module.
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the cooling fan cage assembly.
4. Remove the drive backplane cover.
5. If required, remove the air shroud or remove the GPU air shroud.
6. Route the cable properly to prevent the cable from being pinched or crimped.
NOTE: Refer Cable routing topic for more information.
136 Installing and removing system components