Dell PowerEdge R7615 - Rear Drive Module; Removing the 2 X 2.5-Inch Rear Drive Module

Figure 54. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
Rear drive module
Removing the 2 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the drives.
5. Disconnect the cables from the rear drive module.
NOTE: Refer Cable routing topic for more information.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the rear drive module to the system.
2. Press the blue release tab and holding the edges lift the rear drive module away from the system.
Installing and removing system components
97