Figure 42. Installing the cooling fan cage assembly
Next steps
1. If removed, install the air shroud .
2. Follow the procedure listed in After working inside your system.
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE:
The procedure to remove standard (STD), high-performance silver grade (HPR SLVR), or high-performance gold
grade (HPR GOLD) fan is same.
Steps
Press the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
WARNING: Ensure not to tilt or rotate the cooling fan while removing from the system.
86 Installing and removing system components
To Next Page
Loading...
