Dell PowerEdge R7615 - Installing the 4 X 2.5-Inch Rear Drive Module

Installing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the drives.
5. If installed, remove the BOSS-N1 module.
6. Disconnect the cables from the rear drive module.
NOTE: Refer Cable routing topic for more information.
Steps
1. Align and lower the rear drive module with the guide on the system.
2. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
Figure 58. Installing the 4 x 2.5-inch rear drive module
Next steps
1. Connect and route all the cables to the rear drive module.
2. Install the drives.
3. If removed, install the BOSS-N1 module.
4. If removed, install the air shroud.
5. Follow the procedure listed in After working inside your system.
Installing and removing system components
101