Dell PowerEdge R7615 - Installing the 2 X 2.5-Inch Rear Drive Module

Figure 55. Removing the 2x 2.5-inch rear drive module
Next steps
1. Replace the 2 x 2.5-inch rear drive module.
Installing the 2 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the drives.
5. Disconnect the cables from the rear drive module.
NOTE: Refer Cable routing topic for more information.
Steps
1. Align the slot on the rear drive module with the guide on the system.
2. Lower and press the rear drive module on top of the riser until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
98
Installing and removing system components