Figure 175. Installing the VGA port
3. Connect the VGA port cable to the LC rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
Figure 176. Connecting the VGA port cable to the port on the system
Next steps
1. Install the air shroud or install the GPU air shroud.
2. Follow the procedure listed in After working inside your system.
Installing and removing system components
225
To Next Page
Loading...
