Installing, Removing, and Replacing
file:///T|/htdocs/stor-sys/ML6000/en/html/ch08.htm[9/17/2012 1:50:35 PM]
2 Thumbscrew
5 Lift the module, align it so that it is parallel with the module below it, and slide it into place.
6 Lower the module's guide pin by turning it and pushing it down.
7 Secure the module to the module beneath it by tightening the thumbscrews located at the base of the front and back
of the module. Press down the thumbscrew, and then tighten it.
1 5U Library Control Module (front)
2 Thumbscrews
3 5U Library Control Module (rear)
8 Install the right rack ear. At the front of the library:
a Open the I/E station door. At the lower right corner of the module is a vertical slot. Insert the hinge of the right
rack ear into the slot and then position the holes of the rack ear flush with the rack rail.
To Next Page
Loading...
