Table 21. Front Panel LED indicators (continued)
Library
Condition
Ready/Activity
LED
Cleaning LED Attention LED Error LED
Message on
Display
I/O Station
unlocked
Flashes 2 times
every 3 seconds
OFF OFF OFF N/A
Library firmware
is being updated
Flashes 2 times
every 3 seconds
OFF OFF OFF LOADER
FIRMWARE
UPDATING!
Drive firmware is
being updated
Flashes 2 times
every 3 seconds
OFF OFF OFF DRIVE
FIRMWARE
UPDATING!
Drive dump is
being uploaded to
host computer
Flashes 2 times
every 3 seconds
OFF OFF OFF DRIVE DUMP
DATA
UPLOADING!
Library is offline Flashes 2 times
every 3 seconds
OFF OFF OFF OFFLINE
Cartridge is being
moved
Flashes 2 times
every 3 seconds
OFF OFF OFF READY
Library error
occurred
ON OFF OFF ON *** CHK ***
CODE: [XXXX]
Drive error
occurred
ON OFF OFF ON DRIVE FAULT
CODE: [X]
Cartridge error
occurred
ON OFF ON OFF MEDIA FAULT
CODE: [X]
Cleaning
cartridge expired
ON OFF ON OFF REPLACE
CLEANING
MEDIA
Drive requested
cleaning
ON ON OFF OFF CLEAN DRIVE
Drive is being
cleaned
ON Flashes 1 time per
second
OFF OFF CLEANING...
Library is online
and ready to
receive a
command
ON OFF OFF OFF READY
Reseating cables
To reseat external library cables, complete the following steps:
1. Locate the following cables on the rear panel of the library.
a. SAS attachment for the drive
b. Ethernet cable for connection to a network
c. Power supply cable
2. Check and reseat, if necessary, all of the cables that are connected to your library.
3. Verify that there is no damage to any connector pins.
108 Dell PowerVault TL1000 Tape Autoloader: User's Guide
To Next Page
Loading...
