v Validity - Enable/Disable setting.
v Trap version - v1, v2c, or v3. For v2c and v3, the Inform check box determines whether an SNMP
INFORM request is sent instead of a trap event.
v IP address - IPv4 and IPv6 addresses are supported. Host names can be entered instead of
numerical IP addresses if the DNS server is specified.
v Community (v1 or v2c) - SNMP community name.
v User name (v3 only) - SNMPv3 unique user name.
v Authentication (v3 only) - Authentication algorithm, MD5, or SHA. When an algorithm is specified,
an authentication password and confirmation of the password are required.
v Privacy (v3 only) - Privacy service encryption and decryption algorithm, DES or AES. When an
algorithm is specified, a privacy password and confirmation of the password are required.
6. Enter the SNMPv3 users who are allowed to access the tape library in the SNMPv3 User List menu.
v Validity - Enable/Disable setting.
v User name - SNMPv3 unique user name.
v Authentication - Authentication algorithm, MD5, or SHA. When an algorithm is specified, an
authentication password and confirmation of the password are required.
v Privacy - Privacy service encryption and decryption algorithm, DES or AES. When an algorithm is
specified, a privacy password and confirmation of the password are required.
7. Select the event level to report in the Trap event field.
8. Click Test to send a test trap notification to the enabled IP addresses.
Figure 40. Trap list settings
Figure 41. SNMPv3 user list settings
42 Dell PowerVault TL1000 Tape Autoloader: User's Guide
To Next Page
Loading...
