– Error and Warning events
– Error, Warning, and Information events
Click Test to send a test message to the addresses enabled in the Mail to fields.
Click Submit to transfer the settings to the library. A dialog message is displayed when the settings are
updated successfully.
Click Refresh to read the current settings from the library.
Configuring SNMP trap notifications
Use Configure Library > Notifications > SNMP Settings to configure the trap settings for sending event
information whenever an event of a certain level occurs, and to register users who can access the tape
library with SNMP Version 3. The traps that are supported by the TL1000 Tape Autoloader are listed in
“Trap definitions (types)” on page 128.
Download the SNMP MIB file for this library from www.Dell.com/support. Install the MIB file on your
SNMP server. Refer to your server application documentation for instructions.
Configure SNMP trap notification with the following settings:
v SNMP Enabled - The SNMP Enabled check box must have a check mark to enable SNMP
notifications.
v Community - SNMP community name (for example, “public”)
v Name - Device name (for example, “TL1000 Tape Autoloader”)
v Location - Physical location of the tape library
v Contact - Contact individual's name
v SNMPv3 engine ID - A read-only attribute that identifies the SNMPv3 engine.
v Trap event - Event level notification threshold
– Error events
– Error and Warning events
Figure 96. SNMP settings screen
Operations 81
To Next Page
Loading...
