v Minimum number of lower case alphabetic characters (a-z) - Choose the minimum number of
lowercase alphabetic characters. The factory default value is 1.
v Minimum number of numeric characters (0-9) - Choose the minimum number of numeric characters.
The factory default value is 1.
v Minimum number of special characters (!@#$%^&*()_+={}|[]\;':"<>?,./) - Choose the minimum
number of special characters. The factory default value is 0.
v Maximum number of identical consecutive characters - Choose the maximum number of identical
consecutive characters. The factory default value is 2. There is no limitation if 0 is selected.
v Maximum number of failed logins before password is locked - Choose the maximum number of
failed logins before the password is locked. The factory default value is 5. Possible range for this
configuration option is 0 - 10. There is no limitation if 0 is selected.
v Maximum number of days before password must be changed - Choose the maximum number of
days before the password must be changed. There is no limitation if 0 is selected.
v Minimum number of days before password can be changed - Choose the minimum number of days
before the password can be changed. A password can be changed immediately if 0 is selected.
v Number of password changes before an old password can be used again - Choose the number of
password changes that are required before a password can be used again. A password can be reused
immediately if 0 is selected.
Click Submit to save all the information.
Click Refresh to display the current password settings.
Saving the library configuration
Note: This procedure is recommended.
Each time that you change the configuration of your library, save the configuration. This function also
maintains several library configuration profiles that can be restored to the library when wanted with the
Web User Interface.
To save library configuration:
1. Expand Configure Library, if necessary, and click Save/Restore in the left navigation pane of the Web
User Interface.
2. Click Save to create a configuration file of your library on your computer.
Configuring your library with the Operator Panel
To configure your library with the Operator Panel, complete the following procedures:
1. “Logging in to the Operator Panel”
2. “Configuring network settings” on page 46
3. “Configuring library settings” on page 47
Logging in to the Operator Panel
In many environments, the default network settings might be sufficient to access your tape library on a
network. To change the default network settings with the Operator Panel, complete the following
procedure:
Figure 45. Save configuration
Installation and configuration 45
To Next Page
Loading...
