Dell PowerVault TL1000 - Creating the Rail Assemblies; Installing the Rail Assemblies

7. Install the rail assemblies into the rack (Figure 22). Ensure the 3 holes in the front of the unit align
with the 1U space marked on the vertical rails in Step 2. Secure the rails to the rack with 4 flat-head
screws ▌9▐ on each side of the rack. Use the top and bottom screw locations on the front and rear of
the rack rail (Figure 18 on page 23)).
a29z0018
7
Figure 21. Creating the rail assemblies
a29z0020
9
9
Figure 22. Installing the rail assemblies
Installation and configuration 25