b. Select Set Date or Set Time, and press Enter.
v Date - Enter the date with the MM/DD/YYYY format.
v Time - Enter the time with the HH:MM:SS format.
c. Press Cancel to backtrack through the menu hierarchy.
6. Auto Cleaning (Default: Disabled)
a. Select Cofiguration > Configure Auto Cleaning.
b. Select Enable Auto Cleaning or Disable Auto Cleaning, and press Enter. The Auto Cleaning
function is enabled only if there is at least one inactive position in the magazine in the library.
c. Press Enter again to apply the setting, or Cancel to reject the setting.
d. Press Cancel to backtrack through the menu hierarchy.
Populating the library with cartridges
The magazine is opened with the Operator Panel.
To populate the library with data and cleaning cartridges, complete the following procedure:
1. From the top menu screen on the Operator Panel, press the Minus key to select Unlock Magazine,
and press Enter, or from Web User Interface: Manage Library > Unlock Magazine.
2. Insert cartridges in the magazine.
Note: A blue release gate (▌1▐ in Figure 46) in the upper left corner of each column in the cartridge
magazine prevents each cartridge from falling out of the front of the magazine. When manually
releasing the gate with one hand, position your other hand in front of the column opening to protect
cartridges that are ejected by the internal column spring.
Note: Column 5 Tier 2 is reserved as the exchange position. This position is accessible by the library
only. A locking mechanism prevents insertion of a cartridge into the reserved slot.
Each cartridge must be inserted with the indicator arrow on the leading edge of the upper surface of
the cartridge pointing towards the cartridge magazine (see Figure 47 on page 49).
Note: Do not rely on the bar code label orientation, if attached, to provide an indication of the correct
cartridge orientation. The bar code label is right side up if attached correctly.
Figure 46. Cartridge release gate
48 Dell PowerVault TL1000 Tape Autoloader: User's Guide
To Next Page
Loading...
