Configure the date and time with the following settings:
v NTP Server - Enables time and date control with a time server on the network.
– NTP server address - The IP address of the time server. IPv4 and IPv6 addresses are supported,
depending on the TCP/IP settings. Host names can be entered instead of numerical IP addresses if
Use DNS is selected in the Network settings.
– Time zone - The time zone relative to Greenwich Mean Time (GMT).
v If the time server is disabled, enter the local time and date manually.
– Date - The date with the MM/DD/YYYY format.
– Time - The time with the HH:MM:SS format.
v Auto Adjustment by PC - Select a time interval and click Start to synchronize the library with the
clock on your host computer at regular intervals. The Web User Interface Java Applet must be running
continuously to use this function.
Click Submit to transfer the settings to the library. A dialog message is displayed when the settings have
been updated successfully.
Click Refresh to read the current settings from the library.
Configuring email notifications
Select Configure Library > Notifications > SMTP (Mail) Settings to configure the email settings for
sending event information whenever an event of a certain level occurs.
Configure email notification with the following settings:
v SMTP server address - SMTP mail server IPv4 or IPv6 address (depending on network configuration)
v Sender address - email message header information
v Subject - email message header information
v Mail to - email addresses of contacts to be notified of the event
v Mail event - Event level notification threshold
– Error events
Figure 95. Email settings screen
80 Dell PowerVault TL1000 Tape Autoloader: User's Guide
To Next Page
Loading...
