Table 13. Default library configuration settings (continued)
Configuration Item Default Setting
Static IP address Disabled
IPv6 address 0:0:0:0:0:0:0:0
Prefix length 64
Gateway 0:0:0:0:0:0:0:0
DNS setting Disabled
DNS IP address 0.0.0.0
PHYSICAL
Library name (Blank)
Auto Cleaning Disabled
Bar code label length 8 characters
LOGICAL
Library mode Random
Loop Enabled
Auto Load Enabled
Active slots 9 + 0
ENCRYPTION
Encryption method None
DATE and TIME
NTP server Disabled
NTP server address 0.0.0.0
Time zone (GMT) +00:00
Date (MM/DD/YYYY) 01/08/2008
Auto adjustment by PC Every 1 minute
NOTIFICATIONS
SMTP (mail) settings
Mail server address 0.0.0.0
Mail event Error events enabled
SNMP (trap) settings
Community Public
Trap event Error events enabled
SNMPv3 engine ID (Set by library firmware)
Static library network settings must be entered with the Operator Panel before the library can be accessed
remotely with the Web User Interface. If your system is serviced by a Dynamic Host Configuration
Protocol (DHCP) server, the network parameters are automatically set. Once remote access is established,
you can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to “Configuring your library with
the Operator Panel” on page 45.
30 Dell PowerVault TL1000 Tape Autoloader: User's Guide
To Next Page
Loading...
