a Unroute the power cables from the retention clip on the SD card reader [1].
b Remove the two (M3) screws that secures the SD card reader to the I/O panel and the system board [2].
c Lift the SD card reader from the slot on the system board [3].
Installing the SD card reader
1 Route the power cables back through the retention clip on the SD card reader [1].
2 Insert the SD card reader from the slot on the system board [2].
3 Replace the two (M3) screws that secures the SD card reader to the I/O panel and the system board [3].
54 Removing and Installing components
To Next Page
Loading...
