Dell Precision 3430 Small Form Factor - Intrusion Switch; Removing Intrusion Switch

3 Install the:
a
Hard drive and optical drive module
b Front bezel
c Side cover
4 Follow the procedure in After working inside your computer.
Intrusion switch
Removing intrusion switch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a
Side cover
b Front bezel
c Hard drive and optical drive module
d Heat sink and heat sink fan
3 To remove the intrusion switch:
a Disconnect the intrusion switch cable from the connector on the system board [1].
b Slide the intrusion switch and lift it away from the system [2].
44 Removing and Installing components