17
About your monitor
Electrical specifications
Table 12. Electrical specifications
Description Value
Video input signals HDMI 2.1/USB-C (DP 1.4 Alt Mode), 600 mV for each differential line, 100 ohm input impedance
per differential pair.
AC input voltage/frequency/
current
100 VAC-240 VAC/50 Hz or 60 Hz ± 3 Hz/2 A (typical)
Inrush current 120 V: 30 A (maximum) at 0
°
C (cold start)
240 V: 60 A (maximum) at 0
°
C (cold start)
Power consumption 0.3 W (Off mode)
1
0.3 W (Standby Mode)
1
31.0 W (On Mode)
1
175 W (Maximum)
2
33.0 W (Pon)
3
102.9 kWh (TEC)
3
1
As defined in EU 2019/2021 and EU 2019/2013.
2
Max brightness and contrast setting with maximum power loading on all USB ports.
3
P
on
: Power consumption of On mode as defined in Energy Star 8.0 version.
TEC: Total energy consumption in kWh as defined in Energy Star 8.0 version.
This document is for informational purposes only and reflects laboratory performance. Your product’s performance may vary based
on the software, components, and peripherals you have ordered. There is no obligation to update this information.
Accordingly, the customer should not rely upon this information in making decisions about electrical tolerances or otherwise. No
warranty as to accuracy or completeness is expressed or implied.
NOTE: This monitor is ENERGY STAR certified.
ENERGY STAR is a program run by the U.S. Environmental Protection Agency (EPA) and the U.S. Department of
Energy (DOE) that promotes energy efficiency.
This product qualifies for ENERGY STAR in the factory default settings, and this is the setting in which power
savings is achieved.
Changing the factory default picture settings or enabling other features increases the power consumption that
could exceed the limits necessary to qualify for an ENERGY STAR rating.
For more information about the ENERGY STAR program, go to https://www.energystar.gov.
To Next Page
Loading...
