57
Operating the monitor
You will see the following message before the DDC/CI function is disabled:
Figure 42. Warning message of the DDC/CI
When the monitor goes into Standby mode, the following message appears:
Figure 43. The message of the Standby Mode
Activate the computer and wake up the monitor to gain access to the OSD.
The OSD functions only in the normal operation mode. If you press the joystick during the Standby mode, the following message
appears depending on the selected input:
Figure 44. Warning message of No signal input
Activate the computer and the monitor to gain access to the OSD.
NOTE: The message may slightly vary according to the connected input signal.
If HDMI 1, HDMI 2, or USB-C input is selected and the corresponding cable is not connected, the following message appears:
Figure 45. The message of No HDMI 1 cable
or
Figure 46. The message of No HDMI 2 cable
To Next Page
Loading...
