Dell SonicWALL Secure Mobile Access 8.5
Administration Guide
226
2In the Apply Policy To drop-down menu, select whether the policy is applied to an individual host, a
range of addresses, all addresses, a network object, a server path, or a URL object. You can also select
an individual IPv6 host, a range of IPv6 addresses, or all IPv6 addresses. The Add Policy dialog box
changes depending on what type of object you select in the Apply Policy To drop-down list.
3 Complete the appropriate step that follows depending on your selection in the Apply Policy To menu.
• IP Address - If your policy applies to a specific host, enter the IP address of the local host
machine in the IP Address field. Optionally enter a port range (for example, 4100-4200) or a
single port number into the Port Range/Port Number field. See Adding a Policy for an IP Address
on page 350.
• IP Address Range - If your policy applies to a range of addresses, enter the beginning IP address
in the IP Network Address field and the subnet mask that defines the IP address range in the
Subnet Mask field. Optionally, enter a port range (for example, 4100-4200) or a single port
number into the Port Range/Port Number field. See Adding a Policy for an IP Address Range on
page 351.
• All Addresses - If your policy applies to all IPv4 addresses, you do not need to enter any IP
address information. See Adding a Policy for All Addresses on page 351.
•Network Object - If your policy applies to a predefined network object, select the name of the
object from the Network Object drop-down list. A port or port range can be specified when
defining a Network Object. See Adding Network Objects on page 130
•Server Path - If your policy applies to a server path, select one of the following radio buttons in
the Resource field:
• Share (Server path) - When you select this option, type the path into the Server Path field.
• Network (Domain list)
• Servers (Computer list)
See Setting File Shares Access Policies on page 351.
•URL Object - If your policy applies to a predefined URL object, type the URL into the URL field.
See Adding a Policy for a URL Object on page 352.
• IPv6 Address - If your policy applies to a specific host, enter the IPv6 address of the local host
machine in the IPv6 Address field. Optionally enter a port range (for example, 4100-4200) or a
single port number into the Port Range/Port Number field. See Adding a Policy for an IPv6
Address
on page 354.
• IPv6 Address Range - If your policy applies to a range of addresses, enter the beginning IPv6
address in the IPv6 Network Address field and the prefix that defines the IPv6 address range in
the IPv6 Prefix field. Optionally enter a port range (for example, 4100-4200) or a single port
number into the Port Range/Port Number field. See Adding a Policy for an IPv6 Address Range
on page 354.
• All IPv6 Address - If your policy applies to all IPv6 addresses, you do not need to enter any IP
address information. See Adding a Policy for All IPv6 Addresses on page 354.
4 Select the service type in the Service drop-down list. If you are applying a policy to a network object,
the service type is defined in the network object.
5Select ALLOW or DENY from the Status drop-down list to either allow or deny SMA connections for the
specified service and host machine.
NOTE: These Secure Mobile Access policies apply to the destination address(es) of the
Secure Mobile Access connection, not the source address. You cannot permit or block a
specific IP address on the Internet from authenticating to the SMA/SRA gateway with a
policy created on the Policies tab. However, it is possible to control source logins by IP
address with a login policy created on the user's Login Policies tab. For more information,
refer to Configuring Login Policies on page 380.
NOTE: One or more policies can be added to deny a specific access method that was selected
during the wizard.
To Next Page
Loading...
