Dell X1000 Series

Switch Management 113
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_SwitchManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
To set a local password to control access to Normal and Privilege levels
activities.
1
Click Switch Management > Management Security > Enable Password
for CLI
.
1 Click Edit to enter the fields:
–
Select Enable Access Level — Select the access level to associate with
the enable password. The following access levels are available:
•
Read-Only — Users with this access level can only view
information.
•
Read-Write — Users with this access level can access and use the
Networking Administrator.
–
Password — Enter the enable password.
–
Confirm Password — Confirm the password.
–
Expiry Date — If Global Aging was selected in the Global Password
Management, displays the expiration date of the enable password.
–
Lockout Status — Displays the number of failed authentication
attempts since the user last logged in successfully (if the
Enable
Login Attempts
checkbox is selected in the Global Password
Management page.) Specifies
LOCKOUT , when the user account is
locked.
–
Reactivate Lockout Status — Check to reactivate the specified user’s
access rights. Access rights can be suspended after unsuccessfully
attempting to login.
Active Users
To view the active users on the device:
•Click Switch Management > Management Security > Active Users .
The following fields are displayed for all active users:
–
Name — Active users logged into the device.
–
Protocol — The management method by which the user is connected
to the device.
–
Location — The user’s IP address.