Dell X1000 Series

Network Administration: Link Layer Discovery Protocol (LLDP) 211
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_Network_Admin_LLDP.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
2 Click Edit, Add , and enter the fields:
–
Network Policy Number — Select an available network policy
number.
–
Application — Select the application (type of traffic) for which the
network policy is defined.
–
VLAN ID — Enter the VLAN ID to which the traffic should be sent.
–
VLAN Type —Select whether the traffic is Tagged or Untagged.
–
User Priority — Select the traffic priority assigned to the network
application.
–
DSCP Value — Select the value to be used by neighbors to mark the
traffic sent to the switch.
MED Port Settings
To assign MED network policies to ports:
1
Click Network Administration > Link Layer Discovery Protocol (LLDP)
> MED Port Settings
.
2 The following fields are displayed for each port:
–
LLDP MED Status — Specifies if LLDP-MED is enabled on the
selected port.
–
Network Policy — Specifies whether a network policy is assigned to
the port.
–
Location — Specifies whether the location is advertised.
–
PoE — Specifies whether PoE is enabled on the port
3 To modify network policies on a port, click Edit .
4 Select the port to be configured, and enter the fields for the port:
–
Enable LLDP-MED — Enable/disable LLDP-MED on the port.
–
Available TLVs — Contains a list of available TLVs that can be
advertised by the port. The possible options are:
•
Network Policy — Advertises the network policy attached to the
port.
•
Location — Advertises the port’s location.