Dell X1000 Series

Switch Management 117
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_SwitchManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
– Interface — Select the specific interface to which the rule applies.
–
Source IP Address — Select Enable/Disable to allow or not allow
access, restriction based on the source IP address. When this field is
disabled, the source IP address cannot be entered into a configured
rule.
–
Supported IP Format — Select whether the IPv4 or IPv6 format is
supported for the source IP addresses.
–
IP Address — Enter the interface source IP address for which the rule
applies. This is an optional field and indicates that the rule is valid for
a subnetwork.
– Address Class — Select one of the following options:
•
Subnet Mask — Enter the IP subnetwork mask if Supported IP
Format
is IPv4.
•
Prefix Length — Enter the number of bits that comprise the
source IP address prefix, or the network mask of the source IP
address.
–
Subnet Mask — Enter the subnet mask of the IP address of the
device.
–
Prefix Length — Enter the number of bits that comprise the IP
address prefix of the subnetwork.
–
Action — Select whether to permit or deny management access to the
defined interface. The possible options are:
•
Permit — Permits access to the device.
•
Deny — Denies access to the device.
To activate a profile
1
Click Switch Management > Management Security > Access Profiles
and Rules
.
The currently-defined access profiles are displayed.
2 To activate an access profile, select it in the Active Access Profile field.
3 Click Edit, Settings Icon ().
4 Select one of the following options for Access Profile Name :
–
None — Access is available to all.