Dell X1000 Series

Network Administration: Power Management 319
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_Network_Admin_PowerManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
3 To reset the Cumulative Energy Saved counter, click Reset .
Interface Settings
To display EEE settings on ports:
1
Click Network Administration > Power Management > Green Ethernet
> Interface Settings
.
2 The following is displayed for each port on the device:
–
Port — Port number.
•
Energy Efficient Ethernet .
•
Oper — Displays the operational status of EEE mode.
•
Remote Peer — Displays the operational status of EEE on the
other side of the link.
•
Short-Reach .
•
Oper — Displays the operational status of Short-Reach mode.
•
Fault Reason — Reason if the operational mode is different than
the administrative mode.
•
Energy Detect .
•
Oper — Displays the operational status of Energy Detect mode.
•
Fault Reason — Reason if the operational mode is different than
the administrative mode.
–
Cable Length (Meter) — Indicates the length of the cable.
Link Layer Discovery Protocol (LLDP) Ethernet Details
To display LLDP EEE energy saving operational status on ports:
1
Click Network Administration > Power Management > Green Ethernet
> Link Layer Discovery Protocol (LLDP) Ethernet Details
.
2 The following is displayed for each port on the device:
–
Port — Port number.
–
Oper — Displays the operational status of EEE mode.
–
Resolved Tx Timer (μsec) — Integer that indicates the current
Tw_sys_tx is supported by the local system.