Dell X1000 Series

Network Administration: sFlow 325
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_Network_Admin_sFlow.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
• Global — A globally unique IPv6 address; visible and reachable
from different subnets.
–
IP Address — Enter the receiver’s IP address.
4 Enter the fields:
–
UDP Port — Port to which SYSLOG message are sent.
–
Maximum Datagram Size (Bytes) — Maximum number of bytes that
can be sent to the receiver in a single sample datagram (frame).
sFlow Interface Settings
To sample datagrams or counters from a port, the port must be associated
with a receiver. sFlow port settings can be configured only after a receiver has
been defined in the
sFlow Receiver Settings pages.
To enable sampling and configure the port from which to collect the sFlow
information:
1
Click Network Administration > sFlow > sFlow Interface Settings .
The sflow interface settings are displayed.
2 To associate an sFlow receiver with a port, click Edit, Add , and enter the
fields:
–
Interface Type — Displays the interface type, which is Port.
–
Interface — Select the port from which information is collected.
–
Flow Sampling — Enable/disable flow sampling. Flow sampling
cannot be disabled if
Counters Sampling is disabled.
–
Flow Sampling Average Sampling Rate — If x is entered, a flow
sample will be taken for each x frames.
–
Flow Sampling Receiver Index — Select one of the indices that was
defined in the sFlow Receiver Settings pages.
–
Flow Sampling Maximum Header Size (Bytes) — Maximum number
of bytes that should be copied from a sampled packet.
–
Counters Sampling — Enable/disable counters sampling. Flow
sampling cannot be disabled if
Flow Sampling is disabled
–
Counters Sampling Interval (Sec) — If x is entered, this specifies that
a counter sample will be taken for each x seconds.