Dell X1000 Series - Page 63

Dashboard 63
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_Dashboard.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
– Admin Duplex Mode — Select the port duplex mode (this is only
possible if Auto Negotiation is not enabled). The options are:
•
Full — The interface supports transmission between the device
and the client in both directions simultaneously.
•
Half — The interface supports transmission between the device
and the client in only one direction at a time.
–
Flow Control — Set flow control on the port. The following options
are available:
•
Enable/Disable — Enable/disable flow control on the port
(Enabled is the default).
•
Auto Negotiation — Enables auto-negotiation of flow control on
the port.
7 Click Next to view a summary of the port configuration.
8 Click Apply to save the changes.
LAG
The following processes can be performed in this wizard.
Assign Ports to a LAG
To assign ports to a LAG:
1
Select Assign Ports to a LAG .
2 Click Next .
3 Select one or more ports to assign to a LAG.
4 Enter the following fields:
–
Port Edit Mode — Select one of the following options:
•
Edit LAG Port Assignment — Use to modify the ports in the
LAG.
•
Clear LAG Port Assignment — Use to remove ports from the
LAG.
–
LAG ID — Select a LAG ID.
–
Port VLAN Mode — Select either Access , General or Trunk . See Port
Modes.