23 Remove the camera.
24 Remove the system board.
25 Remove the Display built-in self test button board.
Procedure
NOTE: The following steps are applicable only for non-touch systems.
1 Press the tabs on the cable to release it from the connector.
2 Disconnect the cable from its slot on the middle frame.
3 Press the tabs on the backlight cable.
4 Disconnect the backlight cable from its slot on the middle frame.
5 Open the latch and disconnect the display cable from its slot on the middle
frame.
6 Lift the display cable off the middle frame.
7 Remove the 7 screws (M3X4) that secures the middle frame to display.
123
To Next Page
Loading...
