Dell XPS 27 - Replacing the USB-Dongle Port; Procedure; Post-Requisites

Replacing the USB-dongle port
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Route the USB dongle port cable into the slot on I/O panel .
2 Route the USB dongle port cable through the routing guide on I/O panel .
3 Align the screw holes on the USB dongle port to the screw holes on the I/O
panel.
4 Replace the three screws (M3X4) that secure the USB dongle port to the I/O
panel.
Post-requisites
1 Replace the I/O panel.
2 Replace the system-board shield.
3 Replace the inner frame.
4 Replace the stand.
5 Replace the back cover.
6 Replace the USB dongle-bay cover.
86