Dell XPS 27 - Replacing the Memory Modules; Procedure; Post-Requisites

Replacing the memory modules
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the notch on the memory module with the tab on the memory-module slot.
2 Slide the memory module firmly into the slot at an angle and press the memory
module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and
reinstall it.
3 Slide the tabs on the memory-module shield into the slots on the system-board
shield and snap it into place.
Post-requisites
1 Replace the back cover.
2 Replace the USB dongle-bay cover.
31