Replacing the system-board
shield
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the system-board shield with the screw holes on the
middle frame.
2 Replace the three screws (M3X4) that secure the system-board shield to the
middle frame.
Post-requisites
1 Replace the back cover.
2 Replace the USB dongle-bay cover.
38
To Next Page
Loading...
