Delta C2000 Series - Page 306

Chapter 10 Digital KeypadC2000
10-9
01: Password Decoder
5. Source of the Master Frequency
Command (AUTO) (Pr. 00-20)
6. Source of the Operation Command
(AUTO) (Pr. 00-21)
7. Stop Method (Pr. 00-22)
8. Max. Operation Frequency (Pr. 01-00)
9. Base Frequency of Motor 1 (Pr. 01-01)
10. Max. Output Voltage Setting of Motor 1
(Pr. 01-02)
11. Output Frequency Upper Limit
(Pr. 01-10)
12. Output Frequency Lower Limit
(Pr. 01-11)
13. Accel. Time 1 (Pr. 01-12)
14. Decel Time 1 (Pr. 01-13)
15. Full-load Current of Induction Motor 1
(Pr. 05-01)
16. Rated Power of Induction Motor 1
(Pr. 05-02)
17. Rated Speed of Induction Motor 1
(Pr. 05-03)
18. Pole Number of Induction Motor 1
(Pr. 05-04)
19. No-load Current of Induction Motor 1
(Pr. 05-05)
20. Over-voltage Stall Prevention
(Pr. 06-01)
21. Over-current Stall Prevention during
Acceleration (Pr. 06-03)
22. Derating Protection (Pr. 06-55)
23. Software Brake Level (Pr. 07-00)
24. Emergency Stop (EF) & Force to Stop
Selection (Pr. 07-20)
25. Encoder Type Selection (Pr. 10-00)
26. Encoder Pulse (Pr. 10-01)
27. Encoder Input Type Setting (Pr. 10-02)
28. System Control (Pr. 11-00)
29. Per Unit of System Inertia (Pr. 11-01)
30. ASR1 Low-speed Bandwidth
(Pr. 11-03)
31. ASR2 High-speed Bandwidth
(Pr. 11-04)
32. Zero-speed Bandwidth (Pr. 11-05)
5. TQCPG Mode
01: Password Decoder
Items
1. Password Input (Decode) (Pr. 00-07)
2. Password Setting (Pr. 00-08)
3. Control Mode (Pr. 00-10)
4. Control of Speed Mode (Pr. 00-11)
5. Source of the Master Frequency
Command (Pr. 00-20)
6. Source of the Operation Command
(Pr. 00-21)
7. Max. Operation Frequency (Pr. 01-00)
8. Base Frequency of Motor 1 (Pr. 01-01)
9. Max. Output Voltage Setting of Motor 1
(Pr. 01-02)
10. Full-load Current of Induction Motor 1
(Pr. 05-01)
11. Rated Power of Induction Motor 1
(Pr. 05-02)
12. Rated Speed of Induction Motor 1
(Pr. 05-03)