Delta C2000 Series - Page 313

Chapter 10 Digital KeypadC2000
10-16
10. PLC Function
Press Up/Down key to select a
PLC’s function.
Then press ENTER.
When the PLC function is activated or stopped, the PLC status will be
displayed on main page of Delta default setting.
Option 2: Enable PLC function
Factory setting on the main screen displays
PLC/RUN status bar.
Option 3: Disable PLC function
Factory setting on the main screen displays
PLC/STOP status bar
If the PLC program is not available in the control
board, PLFF warning will be displayed when
choosing option 2 or 3.
In this case, select option 1: No Function to clea
r
PLFF warning.
The PLC function of KPC-CE01 can only displays:
1. PLC0
2. PLC1
3. PLC2
11. Copy PLC
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1. Go to “Copy PLC”
2. Select a parameter group to copy, then press
ENTER.
1. Select 1: Save in the motor drive.
2. Press ENTER key to go to “Save in the moto
r
drive” screen.
Begin to copy PLC until it is done.
Once copying PLC is done, keypad will automaticall
y
be back to this screen.
NOTE
If “Option 1: Save in the motor drive” is selected,
verify if the PLC program is built-in to KPC-CC01
keypad. If PLC program is not available in the keypad
while “Option 1: Save in the motor drive” is selected,
an “ERR8 Warning: Type not matching” will be
displayed on the screen.