Chapter 10 Digital KeypadC2000
10-37
LCM Display * Description Corrective Actions
File is locked with password
A setting cannot be made, because some data are
locked.
1. Verify if the data are unlocked or able to be
unlocked. If the data are unlocked, try to make the
setting again.
2. Shut down the system, wait for ten minutes, and
then power on again the system.
If none of the solution above works, contact your local
authorized dealer.
File password is incorrect
A setting cannot be made because the password is
incorrect.
1. Verify if the password is correct. If the password is
correct, try to make the setting again.
2. Shut down the system, wait for ten minutes, and
then power on again the system.
If none of the solution above works, contact your local
authorized dealer.
Different version of copied data
A setting cannot be made, because the version of the
data is incorrect.
1. Verify if the version of the data matches the motor
drive. If it matches, try to make the setting again.
If none of the solution above works, contact your local
authorized dealer.
AC drive copy function time-out
A setting cannot be made, because data copying
timeout expired.
1. Redo data copying.
2. Verify if copying data is authorized. If it is
authorized, try again to copy data.
3. Shut down the system, wait for ten minutes, and
then power on again the system.
If none of the solution above works, contact your local
authorized dealer.
※ The content in this chapter only applies on V1.01 and above of KPC-CC01 keypad.
To Next Page
Loading...
Need help?
General