Delta C2000 Series - Page 346

Chapter 11 Summary of Parameter SettingsC2000
11-11
Pr. Parameter Name Setting Range Default
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0

01-16 Acceleration time 3
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-17 Deceleration time 3
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-18 Acceleration time 4
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-19 Deceleration time 4
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-20 JOG acceleration time
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-21 JOG deceleration time
Pr. 01-45=0: 0.00–600.00 sec.
Pr. 01-45=1: 0.00–6000.0 sec.
The default of motor drive with 30HP and above:
60.00 / 60.0
10.00

01-22 JOG frequency 0.00–599.00Hz
6.00

01-23
First / Fourth acceleration /
deceleration frequency
0.00–599.00Hz
0.00

01-24 S-curve acceleration begin time 1
Pr. 01-45=0: 0.00–25.00 sec.
Pr. 01-45=1: 0.0–250.0 sec.
0.20

01-25 S-curve acceleration arrival time 2
Pr. 01-45=0: 0.00–25.00 sec.
Pr. 01-45=1: 0.0–250.0 sec.
0.20

01-26 S-curve deceleration begin time 1
Pr. 01-45=0: 0.00–25.00 sec.
Pr. 01-45=1: 0.0–250.0 sec.
0.20

01-27 S-curve deceleration arrival time 2
Pr. 01-45=0: 0.00–25.00 sec.
Pr. 01-45=1: 0.0–250.0 sec.
0.20
01-28 Skip frequency 1 (upper limit) 0.00–599.00 Hz 0.00
01-29 Skip frequency 1 (lower limit) 0.00–599.00 Hz 0.00
01-30 Skip frequency 2 (upper limit) 0.00–599.00 Hz 0.00