Delta C2000 Series - Page 801

Chapter 16 PLC Function ApplicationsC2000
16-40
Command code that can be used
Function Code Description of Function Function target
01 Coil status read Y,M,T,C
02 Input status read X,Y,M,T,C
03 Read single unit of data T,C,D
05 Compulsory single coil status change Y,M,T,C
06 Write single unit of data T,C,D
0F Compulsory multiple coil status change Y,M,T,C
10 Write multiple units of data T,C,D
NOTE
When PLC functions have been activated, the C2000 can match PLC and drive parameters; this method employs different
addresses, drives (default station number is 1, PLC sets station number as 2)