Chapter 5 Main Circuit TerminalsC2000
5-5
Figure 5-7
*1 Please refer to Section 7-1 for brake units and resistors selection.
Note: When wiring for 12 Pulse Input, please strictly follow above wiring diagram, or it may cause the fan
stop unexpectedly. Any questions, please contact Delta Electronics, Inc.
NOTE
If the wiring between motor drive and motor is over 75 meters, please refer to Chapter 7-4 Specifications of limits for motor
cable length.
Please remove short circuit plate of Frame G and H if 12 pulse is implemented
Figure 5-8
Fasten the screw after the copper is removed.
Screw torque: 100~110 kg-cm / [ 86.8~95.5 lb-in.] / [9.8~10.8 Nm]
Detail A
See
Detail A
To Next Page
Loading...
