Chapter 11 Summary of Parameter SettingsME300
11-12
Pr. Explanation Settings Default
12: Output stop
13: Cancel the setting for auto-acceleration / auto-
deceleration time
15: Rotating speed command from AVI
18: Force to stop (Pr.07-20)
19: Digital up command
20: Digital down command
21: PID function disabled
22: Clear the counter
23: Input the counter value
24: FWD JOG command
25: REV JOG command
28: Emergency stop (EF1)
29: Signal confirmation for Y-connection
30: Signal confirmation for Δ-connection
38: Disable writing EEPROM function
40: Force coasting to stop
41: HAND switch
42: AUTO switch
49: Enable Drive
50: Slave dEb action to execute
56: Local / Remote selection
58: Enable fire mode (with RUN command)
59: Enable fire mode (without RUN command)
69: Auto-activate preheating command
70: Force auxiliary frequency return to 0
71: Disable PID function, force PID output return to 0
72: Disable PID function, retain the output value
before disabled
73: Force PID integral gain return to 0, disable integral
74: Reverse PID feedback
77: PLC Program Running
78: PLC Program Step Completed
79: PLC Program Completed
80: PLC Operation Paused
83: Multi-motor (IM) selection bit 0
94: Programmable AUTO RUN
95: Pausing AUTO RUN
97: Multi-pump switch by HAND / AUTO mode
98: Simple positioning stop by forward limit
To Next Page
Loading...
