MS300/MH300 PROFINET Communication Card CMM-PN02
CMM-PN02 Operation Manual
2. As shown in the figure below, after turning on the OB1, drag the WRREC in the extended instruction
on the right side into the network.
3. Follow the three steps in the figure below to add Array_DB.
4. Left click to drag and drop the new Array into the corresponding pane of the block and fill in the
relevant information of the packet being sent. The REQ here indicates whether the function is enabled
or disabled. The ID here can use the hardware number recorded in the first step. The INDEX here is
the number of the record data object. The CMM-PN02 can use the function number 1234 to notify the
motor drive that it needs to do parameter writing. Note that the length of writing parameter should be
6.
To Next Page
Loading...
