Delta RPI M6A

95
Installation and Operation Manual for RPI M6A M8A M10A inverters V1.0 2016-02-03
8 Settings
Fix Q: Ind 90%
Mode: ON
6. To change the mode, use the buttons and to select Mode and press the button
ENT
.
To switch the function on, select ON and press the button
ENT
.
To switch the function off, select OFF and press the button
ENT
. When you switch the
function off, you can ignore the following steps.
Fix Q: Ind 90%
Mode: ON
7. If you need to change the parameter Fix Q, use the buttons and to select the
parameter and press the button
ENT
.
8. To change the parameter value, use the buttons and .
To conrm your setting, press the button
ENT
.
To cancel the action, press the button
ESC
.
9. Repeat steps 7 to 8 for other parameters if you need to change them.
Congurable Parameters
Parameter Description Value range
Mode
Switches the function on and off.
ON | OFF
Default value: OFF
Fix Q
Sets up a constant reactive power which is set in per cent of the
nominal apparent power S
n
.
cap 0 ... 100% | 0 |
ind 0 ... 100%
Do not change this setting without prior
consultation with Delta Solar Support.