Denon AVR-4308 - Record Player; CD Player; Ipod


Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Record Player
• When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
• Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
• With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
(/%
"6%*0
065
R
L
Turntable (MM cartridge)
NOTE
The AVR-4308’s SIGNAL GND terminal is meant to reduce noise when
a record player is connected. This is not a safety ground terminal.
"6%*0
"6%*0
$0"9*"-
065
3-
065
R
L
R
L
CD Player
Connect the cables to be used.
CD player
iPod
®
Example :
"4%3
R
L
R
L
iPod
When using an optical cable for the digital audio connection, make the
settings at GUI menu “Source Select” – “CD” – “Assign” – “Digital”
(vpage 41).
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• To assign the iPod to a connector other than VCR (iPod), make the
settings at GUI menu “Source Select” – “(input source to which iPod
dock assigned)” – “Assign” – “iPod dock” (vpage 41).
Use a DENON Control Dock for iPod (ASD-1R, sold separately) to
connect the iPod to the AVR-4308. For instructions on the Control
Dock for iPod settings, refer to the Control Dock for iPod’s operating
instructions.
Connections
1.AVR4308E2_ENG_3.indd 14 2007/10/26 11:41:14