Denon AVR-4308 User Manual


Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
SOURCE SELECT <PHONES> <MASTER VOLUME>
<ON/STANDBY> <POWER>
[POWER ON]
[MUTE]
[POWER OFF]
[MASTER VOLUME]
SOURCE SELECT
[ AMP]
Playback
Playing Video and Audio Equipment
1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor’s operating instructions.)
2
To operate using the main remote control unit, set the
remote control unit to the AMP mode.
(vpage 64 “Remote Control Unit Operations”)
3
Use SOURCE SELECT to select the input source.
3
: “Source Select” (vpage 38, 39)
4
Start playback.
(vSee the operating instructions of the respective devices.)
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Preparations
1
Press <POWER>.
The power indicator lights red and the power is set to the standby
mode.
2
Press <ON/STANDBY> or [POWER ON].
The power indicator fl ashes green and the power turns on.
To operate the AVR-4308 using the main remote control unit, set the
remote control unit to the AMP mode (vpage 64 “Remote Control
Unit Operations”).
Turning the Power Off
q Press <ON/STANDBY> or [POWER OFF].
The power is set to the standby mode.
w Press <POWER>.
The power indicator turns off, and so does the power.
NOTE
Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long periods
of time or when traveling, either press <POWER> to turn off the power,
or unplug the power cord from the power outlet.
Turning the Power On
Either turn <MASTER VOLUME> or press [MASTER
VOLUME].
Press [MUTE].
To cancel, press [MUTE] again. Muting can also be canceled by adjusting
the master volume.
Plug the headphones into <PHONES>.
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
Be careful not to set the volume too high when using headphones.
Operations During Playback
Adjusting the Master Volume
Turning Off the Sound Temporarily (Muting)
Listening with Headphones
Basic Operation
Playback
1.AVR4308E2_ENG_3.indd 49 2007/10/26 11:42:34

Denon AVR-4308 Specifications

General

Number of Channels	7.1
HDMI Inputs	4
HDMI Outputs	2
Networking	Ethernet, Wi-Fi
Multi-room Zones	3
THX Certified	No
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Total Harmonic Distortion	0.05%
Input Sensitivity/Impedance	200 mV / 47 kOhms
Signal-to-Noise Ratio	102 dB
HDMI Version	1.3a
Dolby Technologies	Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Pro Logic IIx
DTS Technologies	DTS, DTS-ES, DTS 96/24, DTS-HD Master Audio
Tuner Frequency Range	FM: 87.5 MHz - 108.0 MHz, AM: 522 kHz - 1611 kHz
Audio Inputs/Outputs	Analog, Digital Coaxial, Digital Optical, HDMI