70
4. Additional Source mode
4.1. Specications
• The Additional Source setting is added for the custom installer. When the setting is "ON", AUX3-7 is added as a
Source.
It is possible to add the number of Sources for use by assigning various input connectors in Input Assign Menu.
• The added AUX3-7 is displayed and available for selection in the Source related settings such as Input Setup in Setup
Menu.
• The default setting is "OFF".
4.2. Operation
1. Press the "Power Operation (
X
)" button while pressing "BACK" and "CURSOR
f
" buttons on the set to turn the power
on.
2. After the POWER ON sequence, FLD displays the indication for the Additional Source mode.
3. Press the "Cursor
0
"/"Cursor
1
" buttons to select the setting.
ON OFF
Upper
* A d d S o u r c e M o d e
Lower
< O F F >
• ON is selected
Lower
< O N >
• OFF is selected
Lower
< O F F >
4. Press the "ENTER" button to conrm the setting.
5. Protection Pass mode
5.1. Specications
• Turn the power on with Protection disabled.
Except for disabling the Protection detection, this operation is the same as the normal power on.
5.2. Operation
1. Press the "Power Operation (
X
)" button while pressing "DIMMER" and "BACK" buttons on the set to turn the power
on.
2. The POWER ON sequence starts. The Protection detection is disabled.
Upper
P r o t e c t i o n P a s s
Lower
This is displayed for 5 seconds before returning to the normal display.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
