Denon AVR-X6700H - Audyssey; Multeq XT32

Audyssey
®
Set Audyssey MultEQ
®
XT32, Audyssey Dynamic EQ
®
, Audyssey
Dynamic Volume
®
and Audyssey LFC™. These can be selected after
Audyssey
®
Setup has been performed.
For additional information on Audyssey technology, please see
“Explanation of terms” (v p. 329).
0
“MultEQ
®
XT32”, “Dynamic EQ”, “Reference Level Offset”, “Dynamic Volume”,
“Audyssey LFC™” and “Containment Amount” settings are stored for each input
source.
0
When the sound mode is in the “Direct” or “Pure Direct” mode, “MultEQ
®
XT32”,
“Dynamic EQ”, “Dynamic Volume” and “Audyssey LFC™” settings cannot be
configured.
0
When the sound mode is in “DTS Virtual:X” or sound mode that have “+Virtual:X”
in the sound mode name, “Dynamic EQ”, “Dynamic Volume” and “Audyssey
LFC™” settings cannot be configured.
0
This item cannot be selected when a DTS:X format with a sampling frequency of
over 48 kHz is input.
0
“MultEQ
®
XT32”, “Dynamic EQ”, “Dynamic Volume” and “Audyssey LFC™”
cannot be selected when a DTS:X format with a sampling frequency of over 48
kHz is input.
o
MultEQ
®
XT32
MultEQ
®
XT32 compensates for both time and frequency
characteristics of the listening area based on Audyssey
®
Setup
measurement results. Selection is done from three types of
compensation curves. We recommend the “Reference” setting.
Reference
(Default):
Selects the default calibrated setting with
a slight roll off at high frequencies, which
is optimized for movies.
L/R Bypass:
Selects the reference setting, but
bypasses MultEQ
®
XT32 on the front left
and right speakers.
Flat:
Selects the calibrated setting which is
optimized for small rooms where your
listening position is closer to the
speakers.
Off:
Do not use “MultEQ
®
XT32”.
0
When using headphones, “MultEQ
®
XT32” is automatically set to “Off”.
Contents Connections Playback Settings Tips Appendix
201
Front panel Display Rear panel Remote Index